Below is a listing of the main VXI options and accessories. If your required option or accessory is not listed, look no further than your local BAC representative.

Plume abatement coil

A finned discharge coil is installed in your cooling tower discharge and piped in series with the wet coil. This reduces or eliminates plumes and extends the dry cooling capacity. Read more

Sound attenuation

Reducing noise at air intake and discharge points brings us closer to silent cooling equipment.

  • For light sound reduction, ideal for suburban requirements, try the XA sound attenuation.
  • The medium sound reductions attained through XB sound attenuation are perfect for residential sound requirements
  • For heavy sound reductions, XC sound attenuation is the best option, ideal for rural sound requirements. Read more

Baltiguard drive system

With this, operate your system like a dual-speed motor, but with standby reserve capacity to cope with any failure. Read more

Remote sump connection

The best way to prevent a sump freezing is to use the auxiliary remote variety within a heated area. Shutting off the circulating pump allows all the water in the water distribution, as well as that in suspension and the sump to drain freely to the auxiliary sump. Read more

Basin heater package

Thanks to our factory-installed heaters, the water stays at 4°C and never freezes, even during equipments downtime and however cold it gets outside. Read more

Electric water level control package

For perfectly precise water level control, replace the standard mechanical valve with our electrical water level controller. Read more

Platforms

To inspect and maintain from the top of the unit more easily and safely, platforms can be installed. Read more

Ladder, safety cage and handrail

A ladder, safety cage and handrails all facilitate access to the top of the unit and safe inspection of your cooling tower. Read more

Extended lubrication lines

Extended lubrication lines with easily accessible grease fittings can be used to lubricate fan shaft bearings. Read more.

Discharge hood

Discharge hoods reduce the risk of re-circulation in tight enclosures by increasing discharge air velocity, and can be used to elevate the unit discharge above adjacent walls to comply with layout guidelines. Read more

Positive closure dampers

Use positive closure dampers (PCD) to minimize the heatloss due to convection by preventing air flow through equipment that is shut down. Read more

Safety switch

Cuts power to motors with safety in mind during inspection or maintenance. Read more

Solid bottom panels

You need factory-installed bottom panels when intake air is ducted to the unit. Read more

Standby pump

Install a standby reserve spray pump as failure backup! Read more

Water treatment equipment

Devices to control water treatment are needed to ensure proper cooling tower water care. Not only does this help protect the components and fill pack, controlling corrosion, scaling and fouling, it also avoids the proliferation of harmful bacteria, including legionella, in the recirculating water. Read more

Filter

Separators and media filters efficiently remove suspended solids in the recirculating water, reducing system cleaning costs and optimizing water treatment results. Filtration helps you keep the recirculating water clean. Read more

Sump sweeper piping

Sump sweeper piping prevents sediment collecting in the cold water basin of the unit. A complete piping system, including nozzles, is installed in the basin of the tower for connection to side stream filtration equipment. Read more

Clean out port

Clean out port makes it easy to eliminate silt and sludge from the cooling tower basin when cleaning and flushing the sump. Read more

Steel drift eliminators

Steel drift eliminators are more robust than plastic alternatives. Read more

Flanges

Flanges facilitate piping connections on-site. Read more